top of page

3 Person Stage Design Project

This was the second design I made. It was by far the most complex and used several different models. It was the most resource heavy model and has some of the more intricate designs in this whole project.

- 3 Person Stage Design Model, Initial Design: This was the first section I built. This is the rear view that showed the shaping of the inside of the stage. It also consists of the top view of the initial design that showed the upper design extents, and this was the frontal view of the initial design. This shows some of what the crowd would see during a performance. Next is the right side view. As you can see, the vertical line coming across the lower section and running to the smaller upper section was a purely artistic design. Last there was the left side design. I was not able to carry the continuous line on this side, as it wouldn't work out.

-3 Person Stage Design, Revision 1: This was the first section I built. This is the rear view that showed the shaping of the inside of the stage.

-3 Person Stage Design, Revision 2: This was a more complete revision, adding two Native Instruments Kontrol Z1's, a Roland SPD-SX, a Novation Launchkey 61, a Access Virus Ti2 Polar and an M-Audio Oxygen 25.

-3 Person Stage Design, Revision 2.5: This is an inbetween revision, essentially adding this drumkit and nothing else. This a second picture of the drumkit, from where the drummer would sit. This is a top view of the drumkit. There was a small addition to the center artist's workstation, adding two V-Drums, a set of drumsticks, and a generic laptop model.

-3 Person Stage Design, Revision 3: This was another small addition, adding a character model to the drummer position (all relations to those living or dead is purely coincidental.) There was a character model added to the front artist design. There was also the start of the keyboardist section. This consists of a Native Instruments Komplete Kontrol S61 and a Yamaha SP33.

-3 Person Stage Design, Revision 4: This was the last part of the 3 person design. This completes the keyboardist section, adding a character model and a guitar. .(wasn't able to find the specific model I used.) Finally, there was a top down view of the completed design, showing the keyboardist/guitarist section, the main artist section and the drummer section.

bottom of page